G196044 (IDT), Class C
The hold-up detectors are used with manual control for inconspicuous hold-up alarm actuation. Actuating the pressure plate will trigger the alarm signal at the hold-up and intrusion detection control panel and necessarily destroy the indicator paper at the same time, thus displaying the alarm triggering permanently.
The detector must be placed to allow an inconspicuous alarm actuation and prevent the committer from seeing the triggered LED (in detectors with LED).
The hold-up detectors meet the requirements of the hold-up detection systems for connection to the police or security service.
- Pulse triggering, thus alarm repetition possible
- Cover contact for sabotage monitoring
- Triggering identification by paper seal or LED
- Seal: Paper insert
- Surface- and flush-mounting of the connecting cables possible
| Switching voltage |
max. 100 V DC |
| Max. actuating direct current |
500 mA |
| Contact load |
6 W or 6 VA |
| Contact resistance |
max. 0,15 Ohm |
| Operating voltage |
max. 40 V |
| Breakdown voltage |
>250 V |
| Cable length |
2 m (LIYY 4 x 0,14 mm²), LSA qualified |
| Type of protection EN 60529 |
IP67 |
| Environmental class as per VdS |
III (VdS 2110) |
| Protective tube |
0,5 m, stainless steel PVC jacketed, o.d. 9 mm |
| Housing material |
Polyamid GF |
| Dimensions contact housing (W x H x D) |
146 x 16,5 x 50 mm |
| Dimensions magnet housing (W x H x D) |
66 x 35 x 40 mm |
| Temperature range |
- 40 °C to + 70 °C |
| Colour |
grey |
Use antimagnetic screws only.
